Lexmark T620 Technical Reference - Page 158

3-88 PJL Table 3-22: Variables for Flash and Disk File and Password Commands (Continued) Parameter location Syntax START = location Description The location in the file to begin writing or reading. Use an integer that represents an offset in bytes from the beginning of the file. Optional for both LREADFILE and LWRITEFILE commands. If omitted on an LREADFILE command, location of 0 (beginning of the file) is assumed. If omitted on an LWRITEFILE command with an accesstype of RW, location of 0 is also assumed. If a START location is provided but it is greater than the file size, the LREADFILE command response will contain no file data. Similarly, an LWRITEFILE command with an accesstype of RW functions like an LWRITEFILE command with an accesstype of AP. Note: If PostScript emulation is used to create the file on the device, it may automatically attach a .data extension to the fname. See "Filename Extensions" on page 6-10 for more information. For example, if "myfile" is downloaded to flash through PostScript emulation, the fname on the PJL commands is "myfile.data". LOPENFILE Command Use this command to open a file on a storage device. Syntax: @PJL LOPENFILE DEVICE = filedevice FILENAME = "fname" ACCESS = accesstype[] LCLOSEFILE Command Use this command to close a file on a storage device. The command is ignored if the file doesn't exist on the device or if the file is not open. Syntax: @PJL LCLOSEFILE DEVICE = filedevice FILENAME = "fname"[]