Lexmark W820 Service Manual - Page 115
Tray Harness Assembly Removal
UPC - 734646210508
View all Lexmark W820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
4025-Finisher Tray Harness Assembly Removal Removal 1. Remove the Rear Cover. 2. Open the Top Cover of the H-Tra. 3. Remove the Sensor. 4. Unclamp the H-Tra harness assembly at seven places on the H-Tra. 5. Unclamp the H-Tra harness assembly at four places on the H-Tra. 6. Unplug the connector (P/J 256M) of the solenoid assembly. 7. Unplug three connectors (P/J 882A,879A,880A) of the harness connection, and remove the harness connection. 8. Unplug the connector (P/J 260) of the H-Tra harness assembly from the sensor. 9. From the lower side, tighten the latch of clamp on the bracket assembly with radio pliers to release the H-Tra harness assembly together with the clamp. 10. Pull the connector (P/J 263) and the harness of the spring tension 80 off the hole on the rear of the H-Tra. 11. Pull the connectors (P/J 275M,259) and the harnesses of the spring tension 80 and sensor full off the hole on the rear of the H-Tra. 12. Unclamp the H-Tra harness assembly at four places on the bracket assembly, and remove the tray harness assembly. Removal and Replacement Procedures 4-7