Lexmark X560n Clearing Jams Guide - Page 1
Lexmark X560n Manual
View all Lexmark X560n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Lexmark™ X560 Clearing Jams Guide Avoiding and clearing jams Avoiding jams The following hints can help you avoid jams: • Use only recommended paper or specialty media. For more information, see the Card Stock & Label Guide available on the Lexmark Web site at www.lexmark.com/publications. • Do not load too much paper. Make sure the stack height does not exceed the indicated maximum height. • Do not load wrinkled, creased, damp, or curled paper. • Flex, fan, and straighten paper before loading it. • Do not use paper that has been cut or trimmed by hand. • Do not mix paper sizes, weights, or types in the same stack. • Store the paper in an appropriate environment. • Do not remove trays while the printer is printing. • Push all trays in firmly after loading paper. • Make sure the guides in the trays are properly positioned, and are not pressing too tightly against the paper. • Make sure all printer cables are attached correctly. For more information, see the setup documentation. Understanding jam messages and locations Open doors and covers, and remove trays to access jam locations. The illustration shows possible jam locations. To resolve any jam message, you must clear all paper from the paper path. Jam message Area name 7 Jam at Scanner ADF tray Open ADF Cover R and Remove Paper Turn the Green Dial to Remove Paper Clearing Tray 1 (MPT) jams If the paper did not feed from the multipurpose feeder correctly, Jam at Tray 1 appears. 1 Pull the jammed paper out of the multipurpose feeder tray, and then remove any remaining paper from the tray. Jam message 1 Jam at Exit Open Door A 2 Jam at Reg. Roll Open Door A 3 Jam at Duplexer Open Door A Lift Belt Unit 4 Jam at Tray 3 Open Tray 3 Open Door A 5 Jam at Tray 2 Open Tray 2 Open Door A 6 Jam at Tray 1 Check Tray 1 Open Door A Area name Fuser top Fuser bottom Optional duplex unit Optional 550-sheet tray (Tray 3) Standard tray (Tray 2) Multipurpose Feeder (Tray 1) 2 Push the release button, and gently lower the front door. CAUTION-HOT SURFACE: To reduce the risk of injury from a hot component, allow the surface to cool before touching it. 1