Lexmark X864 IPDS Printer and Host Setup Guide - Page 16

IPDS Printer and Host Setup Guide PSF/MVS LAN Printing Using the Standard Network Port or Internal Print Server Step 2 Define the printer to JES a) Example for JES2 FSS(FSS1) PRT7 PROC=PSFPROC,HASPFSSM=HASPFSSM FSS=FSS1,MODE=FSS, PRMODE=(LINE,PAGE,SOSI1,SOSI2), CLASS=C,UCS=0,SEP,NOSEPDS,CKPTPAGE=100, DRAIN,MARK,TRKCELL=YES b) Example for JES3 FFSDEF,TYPE=WTR,FSSNAME=FSS3,PNAME=SAMPLE01, SYSTEM=SYS1,TERM=NO, DEVICE,DTYPE=PRTAFP1,NAME=PRT7, JUNIT=(,SYS1,,OFF),FSSNAME=FSS3, MODE=FSS,PM=(LINE,PAGE,SOSI1,SOSI2),CHARS=(YES,GT12), CARRIAGE=(YES,A868),CKPNTGP=100,HEADER=YES, WC=(C) Step 3 Add the printer to the PSF STARTUP PROC Add printer to PSFSTARTUP PROC. Parameters to change are shown in bold. // PRT7 CNTL /* */ // PRT7 PRINTDEV FONTDD=*.FONT01, /* FONT */ // OVLYDD=*.OLAY01, /* OVERLAY */ // PSEGDD=*.PSEG02, /* SEGMENT */ // PDEFDD=*.PDEF01, /* PAGEDEF */ // FDEFDD=*.FDEF01, /* FORMDEF */ // JOBHDR=*.JOBHDR /* JOB HEADER */ // JOBTRLR=*.JOBTLR /* JOB TRAILER */ // DSHDR=*.DSHDR, /* DATA SET HEADER */ // FORMDEF=A10110, /* FORMDEF */ // PIMSG=(YES,16), /* MESSAGES */ // DATACK=UNBLOCK, /* REPORT ALL DATA CHECKS */ // TRACE=NO, /* INTERNAL TRACE */ // MGMTMODE=OUTAVAIL, /* PRINTER MANAGEMENT MODE */ // CONNINTV=0, /* NO TIMEOUT */ // DISCINTV=15, /* TIMEOUT=15 SECONDS */ // TIMEOUT=REDRIVE, /* PSF ACTION ON TIMEOUT */ // FAILURE=WCONNECT, /* ATTEMPT RECONNECT */ // IPADDR='157.184.67.102', /* IP ADDRESS FOR PRINTER */ // PORTNO=5001, /* PORT ADDRESS FOR PRINTER*/ // PRT7 ENDCNTL /* */ The value (15) for DISCINTV specifies the time in seconds after which PSF ends the printer session when no output is available. The valid range is from 0 to 8160 seconds. The default value is 0. If DISCINTV=0, the PSF does not end the printer session when no output is available. Refer to "Printer and Host Timeout Values" [page 34] for information on selecting the DISCINTV value. 16