LiftMaster H J - NEW STYLE DISCONNECT Manual - Page 4
Important Safety Notes, Site Preparations, Operator Preparation, Warning - series
View all LiftMaster H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
IMPORTANT SAFETY NOTES CAUTION WARWNAINRGNING W TO AVOID DAMAGE TO DOOR AND OPERATOR, MAKE ALL DOOR LOCKS INOPERATIVE. SECURE LOCK(S) IN "OPEN" POSITION. IF THE DOOR LOCK NEEDS TO REMAIN FUNCTIONAL, INSTALL AN INTERLOCK SWITCH. DO NOT CONNECT ELECTRIC POWER UNTIL INSTRUCTED TO DO SO. KEEP DOOR BALANCED. STICKING OR BINDING DOORS MUST BE REPAIRED. DOORS, DOOR SPRINGS, CABLES, PULLEYS, BRACKETS AND THEIR HARDWARE MAY BE UNDER EXTREME TEN- SION AND CAN CAUSE SERIOUS PERSONAL INJURY. CALL A PROFESSIONAL DOOR SERVICE- MAN TO MOVE OR ADJUST DOOR SPRINGS OR HARDWARE. CAUTION SITE PREPARATIONS It is imperative that the wall or mounting surface provide adequate support for the operator. This surface must: a) Be rigid to prevent play between operator and door shaft. b) Provide a level base. c) Permit the operator to be fastened securely and with the drive shaft parallel to the door shaft. The safety and wear of the operator will be adversely affected if any of the above requirements are not met. For metal buildings, fasten 2" x 2" x 3/16" (or larger) angle iron frames to the building purlins. Retain 51/2" between frames. See Figure 1. Shaft Support Bracket with Bearing (Not Supplied) Door Sprocket WARNING ALL DOORS INTENDED TO BE MOTOR OPERATED SHOULD BE MANUFACTURED WITH SOLID DOOR SHAFTS. WARNING 52-1/24"" FIGURE 1 CAUTIOONPERATOR PREPARATIWONARNING Both J and H series operators have dual output shafts and may be mounted on either the right (stan- dard) or left side of door, and in either a vertical (standard) or horizontal mounting position. If you need to move the drive sprocket, loosen BOTH set screws, remove the sprocket and key, and place on the opposite side of the drive shaft. Be sure to tight- Output en BOTH set screws securely Shaft Hand Chain Handing For models H and HJ with manual hoist hand chain systems, the handing of the operator must be determined at the time of order. The handing is indicated by last letter of the model name (R or L). The hand chain wheel can not be switched on site. If your installation causes the hand chain to hang in the door opening, hook the chain off to the side near the top of the door jamb. (2) Set Screws Key Drive Sprocket 4