Linksys LNE100TX User Guide - Page 26

Linksys Instant EtherFast® Series Windows 2000 Installation and Setup Overview After physically installing the EtherFast® 10/100 LAN Card in your computer, follow these instructions to install the network device driver. Note: Prior to proceeding, ensure that you are operating The installation procedure for the network driver Windows 2000 will vary slightly depending on which version of with administrative rights. If Windows 2000 you are using, and on your cur- you log into Windows 2000 without administrative rights, rent system configuration. If at any time during you may run into problems the installation you encounter problems, consult during the installation. the Troubleshooting section. Note: Do not click Cancel or Skip at any time during the installation. Doing so will pre- vent your driver from being properly installed on your PC. Installing the Network Card's Driver 1. Start and log on to your Windows 2000 PC. 2. Windows will display the Found New Hardware Wizard box. Click the Next button to continue. EtherFast® 10/100 LAN Cards 3. The Install Hardware Device Drivers dialog box will appear. When Ethernet Controller is displayed, select Search for a suitable driver for my device (Recommended) and click the Next button. 4. The Locate Driver Files dialog box will appear. Select Specify a location and click the Next button. 45 46