Magnavox 19MD359B User Manual - Page 45

INTRODUCTION PREPARATION WATCHING TV OPTIONAL SETTING OPERATING DVD DVD SETTING TROUBLESHOOTING INFORMATION Stereo Sound Mode CD This unit allows you to select a sound mode during CD playback. During playback, press [SAP/AUDIO] repeatedly until the desired sound mode appears. STEREO Marker Setup This feature allows you to assign a specific point on a disc to be called back later. To set a marker 1 During playback, press [MODE] repeatedly until " " / " " appears. e.g.) DVD _ _ /12 (SEARCH) • Each time you press [SAP/AUDIO], the sound mode changes as example below. STEREO (stereo sound with left and right channels) L-ch (left channel sound only) R-ch (right channel sound only) Note: • Virtual surround cannot be changed when the sound mode is set to either "L-ch" or "R-ch". Virtual Surround You can enjoy virtual surround on your 2 channel stereo system. 1 During playback, press [MODE] repeatedly until " " appears. OFF (SURROUND) 2 Use [Cursor K/ L] repeatedly until marker search menu appears. 1 2 3 4 5 6 7 8 9 10 AC 3 Use [Cursor s / B] to select an available marker within 60 seconds. 1 2 3 4 5 6 7 8 9 10 AC 4 When the playback reaches the point at which you want to set a marker, press [OK]. • Marker is now set. 2 3 4 5 6 7 8 9 10 AC 5 Press [BACK] to exit. 2 Press [Cursor K/ L] to select the sound level. 1 (SURROUND) 1 : Natural effect. 2 : Emphasized effect. OFF : No effects (original sound). 3 Press [BACK] to exit. Note: • The setting will be kept even if the unit is turned off. • For audio CD, virtual surround will not be effective if the sound mode is set to something other than "STEREO". (Refer to "Stereo Sound Mode" on page 45.) • Turn down the level or select "OFF" if the sound is distorted. To return to the marker later 1 Repeat steps 1-2 in "To set a marker". Use [Cursor s / B] to select the desired marker. e.g.) DVD 2 3 4 5 6 7 8 9 10 AC 2 Press [OK] at the desired marker to restart playback from the specific point which you set. 2 3 4 5 6 7 8 9 10 AC Note: • Marker search menu will disappear in about 60 seconds when there is no input. • You can mark up to 10 points. • To clear a marker, select the marker to be cleared, and then press [CLEAR]. • Ejecting the disc or turning off the power will erase all markers. • Selecting " " at step 3 in the section "To set a marker" will also erase all markers. 45 EN