Makita EK6101 Operation Manual - Page 17

Refuelling, IMPORTANT, Starting the engine, CAUTION

Get Makita EK6101 PDF manuals and user guides View all Makita EK6101 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Refuelling IMPORTANT: FOLLOW THE SAFETY PRECAUTIONS! Be careful and cautious when handling fuels. The engine must be turned off and cooled down! Carefully clean the area around the fuel‑tank filler neck to keep dirt from getting in the tank. Place the Power Cut on an even surface. Unscrew the tank cap and fill tank with fuel mixture. Take care to avoid spilling. Screw the tank cap back on hand-tight. Clean screw cap and tank after refuelling. Never start or operate the Power Cut in the same place as it was fuelled! If fuel gets on your clothing, change clothes immediately. Fuel mixture 3 meters Starting the engine if necessary CAUTION: Observe the SAFETY INSTRUCTIONS on page 7 and 8! Start the Power Cut only after complete assembly and inspection! Move at least 3m (10 feet) away from the place where you fuelled the Power Cut. Make sure you have a good footing, and place the Power Cut on the ground in such a way that the cutting disc is not touching anything. 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
17
Refuelling
IMPORTANT:
FOLLOW THE SAFETY PRECAUTIONS!
Be careful and cautious when handling fuels.
The engine must be turned off and cooled down!
Carefully clean the area around the fuel-tank filler neck to keep
dirt from getting in the tank.
Place the Power Cut on an even surface.
Unscrew the tank cap and fill tank with fuel mixture. Take care
to avoid spilling.
Screw the tank cap back on hand-tight.
Clean screw cap and tank after refuelling. Never start or op-
erate the Power Cut in the same place as it was fuelled!
If fuel gets on your clothing, change clothes immediately.
Fuel mixture
Starting the engine
if
necessary
CAUTION:
Observe the SAFETY INSTRUCTIONS on page 7 and 8!
Start the Power Cut only after complete assembly and
inspection!
Move at least 3m
(10 feet)
away from the place where you
fuelled the Power Cut.
Make sure you have a good footing, and place the Power
Cut on the ground in such a way that the cutting disc is
not touching anything.
3 meters