Maytag MDB8959SK Owners Manual - Page 25

Option A: Waste disposer-no air gap Disposer inlet Large drain hose clamp Drain hose Option B: No Waste disposer-no air gap Waste tee Large drain hose clamp Drain hose Drain trap Helpful Tip: Remove disposer knockout plug. 1. Using a hammer and screwdriver, knock 1 plug into disposer. 1 Rubber end 2 2. Use needle-nose pliers to remove plug. 2 Drain trap 1. Fit rubber end of drain hose to waste tee. 2. Attach rubber end of drain hose to waste tee with a large drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 11/2" to 2" (3.8 cm to 5.0 cm) screw-type clamp (not provided). 3. Attach drain hose to disposer inlet with Option C: Waste disposer - with air gap 3 large drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. Screw-type clamps Air gap Large drain hose clamp Disposer inlet Rubber hose connector Drain hose Drain trap Helpful Tip: Remove disposer knockout plug. 1 1. Using a hammer and screwdriver, knock plug into disposer. 2 2. Use needle-nose pliers to remove plug. 3 Rubber end 3. Connect rubber end of drain hose to air gap. NOTE: Do not cut ribbed section. 25