McAfee IIP-M65K-ISAA Product Guide - Page 19

Setting up the Sensor Redundant power supply 3 Because of the weight of the appliance, McAfee recommends that two people remove the chassis from the rail cabinet. When removing the chassis from the rack, pull the chassis forward until you hear the innermost rails snap in place. On each side of the rails, press in the release button as pictured below and continue pulling the chassis. Figure 3-1 Rail release latch Redundant power supply A basic configuration of the Sensor includes one hot-swappable supply. You can install a second hot-swappable power supply for redundancy. You will have to purchase this redundant power supply separately from McAfee. Each of these modules have one handle for insertion or extraction from the unit as well as a release latch. Figure 3-2 Power supply units Install the power supply Task 1 Unpack the power supply from its shipping carton. 2 Remove the faceplate panel covering the power supply slot. The faceplate panel must remain in place unless a power supply is in the power supply slot. Do not operate the Sensor without the faceplate panel in place. McAfee® Network Security Platform M-6050 Sensor Product Guide 19