Netgear FWG114P FWG114P Reference Manual - Page 34

Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P 4. RUN THE SETUP WIZARD TO CONNECT TO THE INTERNET Figure 3-7: Setup Wizard a. You are now connected to the router. If you do not see the menu above, click the Setup Wizard link on the upper left of the main menu. b. Choose NAT or Classical Routing. Typically, NAT is used. NAT automatically assigns private IP addresses (192.168.0.x) to LAN connected devices. Classical routing lets you directly manage the IP addresses the FWG114P uses. Note: If you choose not to use NAT, each computer on the LAN connected to the FWG114P must have a valid public IP address in the same subnet as the Wan port of the FWG114P. For more information on NAT, please see "Single IP Address Operation Using NAT" on page B-7. Furthermore, if you turn NAT off and plan to use VPN, you will have to open UDP port 500 in the Security settings according to the instructions at c. Click Next to proceed. Input your ISP settings, as needed. d. At the end of the Setup Wizard, click the Test button to verify your Internet connection and register your product. If you have trouble connecting to the Internet, use the Troubleshooting Tips below to correct basic problems, or refer to the Reference Manual on the CD. If you were unable to connect to the firewall, please refer to Basic Functioning "Basic Functioning" on page 11-1. You are now connected to the Internet! Note: For wireless placement and range guidelines, and wireless configuration instructions, please see Chapter 4, "Wireless Configuration." 3-8 Connecting the FWG114P to the Internet March 2004, 202-10027-01