Netgear GSM7224v1 GSM7212 Hardware manual - Page 10
GSM7212 Rear Panel, Table 2-1. LED Descriptions for GSM7212,
View all Netgear GSM7224v1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Managed Layer 2 Switches GSM7212, GSM7224, and GSM7248 Hardware Installation Guide The following table describes the LEDs on the front panel of the switch. Table 2-1. LED Descriptions for GSM7212 LED Description Power Mode MaxSpd (maximum speed), ACT (activity) or FDX Link (port number) SFP Port (1,000 Mbps only) • Green: Power is supplied, and the switch is operating normally. • Yellow: Power supply present, but it has failed. • Off: Power is disconnected. MaxSpd (maximum speed) • Green: Link in 1,000 Mbps. • Yellow: Link in 100 Mbps. • Off: Link in 10 Mbps. ACT (activity) • Blinking green: The port is sending or receiving packets. FDX • Green: Full-duplex mode. • Yellow: Half-duplex mode. • Blinking yellow: Collision occurred when sending and receiving in half-duplex mode. • Green: A valid 1,000 Mbps link is established on the port. • Yellow: A valid 100 Mbps link is established on the port. • Off: A valid 10 Mbps link is established on the port.. • Solid green: Link is up. • Blinking green: The port is sending or receiving packets in link up status. • Off: No link is detected. GSM7212 Rear Panel The rear panel has a standard AC power receptacle for the supplied power cord. Power receptacle Figure 2-2 2-2 v1.0, March 2006 Introduction