Netgear GSM7252PS GSM72xxPS and GSM73xxSv2 Series Managed Switch Hardware Inst - Page 12

Managed Stackable Switches GSM7200PS and GSM7300S Series Hardware Installation Guide Table 1-5. LED Descriptions for GSM7328S (Continued) LED Description 10/100/1000M Ports (2 LEDs per port) Link/ACT LED: • Off: No link is established on the port. • Solid green: A valid link is established on the port. • Blinking green: The port is sending or receiving packets. SPD LED: • Off: No link is established on the port. • Solid yellow: A valid 10/100 Mbps link is established on the port. • Solid green: A valid 1000 Mbps link is established on the port. Note: If port 21-24 media is changed to SFP, the RJ-45 LEDs change to OFF status. SFP Ports (1Link/ACT LED per port) • Off: No SFP module link is established on the port. • Solid green: A valid 1000Mbps SFP module link is established on the port. • Blinking green: Packet transmission or reception is occurring on the port at 1000Mbps. • Solid yellow: A valid 100Mbps SFP module link is established on the port. • Blinking yellow: Packet transmission or reception is occurring on the port at 100Mbps. Note. If port 21-24 media is changed to copper, the SFP LEDs change to OFF status. SFP+ Ports (1 Link/ACT LED per port) SPD/Link/ACT LED: • Off: No SFP module link is established on the port. • Solid green: A valid 10Gbps SFP+ module link is established on the port. • Blinking green: Packet transmission or reception is occurring on the port at 10Gbps. GSM7328S Rear Panel The rear panel has two module bays, a console port, redundant power supply connector, and a power module for the supplied power cord. Power receptacle Console Stacking/XFP/SFP+/CX4 module bays Redundant power supply connector Figure 1-6 GSM7328S Rear Panel The module bays support any combination of the following: • ProSafe 10-Gigabit Ethernet XFP Adapter (AX741) 12 | Chapter 1: Introduction Replaceable power supply