Netgear GSM7252PS GSM72xxPS and GSM73xxSv2 Series Managed Switch Hardware Inst - Page 14

Managed Stackable Switches GSM7200PS and GSM7300S Series Hardware Installation Guide Table 1-6. GSM7352S LED Description (Continued) LEDs Description 10/100/1000M Ports (2 LEDs per port) Link/ACT LED: • Off: No link is established on the port. • Solid green: A valid link is established on the port. • Blinking green: The port is sending or receiving packets. SPD LED: • Off: No link is established on the port. • Solid yellow: A valid 10/100 Mbps link is established on the port. • Solid green: A valid 1000 Mbps link is established on the port. Note: If port 41~48 media changes to SFP, the RJ-45 LEDs change to OFF status M1, M2 High-Speed I/O Modules (1 LED per module) • Off: No module is present or a module is present but is not linked with the system. • Solid green: A module is present and linked up with the system. • Blinking green: The port is transmitting or receiving packets. SFP ports • Off: No SFP module link is established on the port. • Solid green: A valid 1000Mbps SFP module link is established on the port. • Blinking green: The port is transmitting or receiving packets at 1000Mbps. • Solid yellow: A valid 100Mbps SFP module link is established on the port. • Blinking yellow: The port is transmitting or receiving packets at 100Mbps. Note: If port 43~48 media is changed to copper, the SFP LEDs change to OFF status. SFP+ Ports (1 Link/ACT LED per port) SPD/Link/ACT LED: • Off: No SFP module link is established on the port. • Solid green: A valid 10Gbps SFP+ module link is established on the port. • Blinking green: The port is transmitting or receiving packets at 10Gbps. GSM7352S Rear Panel The rear panel has two module bays, a redundant power supply connector, a console port, and a power module bay for the APS135W. Power receptacle Console Stacking/XFP/SFP+/CX4 module bays Figure 1-8 GSM7352S Rear Panel 14 | Chapter 1: Introduction Redundant power supply connector Replaceable power supply