Netgear GSM7352SNA GSM7328S, GSM7352S and GSM7328FS Hardware Installation Guid - Page 16

Managed Stackable Layer 3 Switches GSM7328S, GSM7352S and GSM7328FS Hardware Instal- Table 2-2. GSM7352S LED Description (continued) LED M1, M2, M3, M4 High-Speed I/O Modules (1 LED per module) SFP ports Description XFP Module present or Stacking Adapter present and ACT LED XFP Module present LED /ACT • Off: The 10GbE Adapter is not present. • Solid green: The 10GbE Adapter is present. • Blinking green: Packets transmission or reception is occurring on the port. Stacking Adapter Link/ACT LED • Off: Stacking module is not present . • Solid green: Stacking module is present . • Blinking green: Packets transmission or reception is occurring on the port. • Link/ACT LED • Off: No SFP module link is established on the port. • Solid green: A valid SFP module link is established on the port. • Blinking green: The port is sending or receiving packets. Note: If port 41~48 media is changed to copper, the SFP LEDs change to OFF status. GSM7352S Rear Panel The rear panel has four module bays, a redundant power supply connector, a console port, and a standard AC power receptacle for the supplied power cord. The module bays support any combination of either the ProSafe 10-Gigabit Ethernet XFP Adapter (AX741) or the ProSafe 24-Gigabit Stackable Module (AX742). See "High-Speed I/O Module Bays" in Chapter 3. Power receptacle Figure 2-4 2-6 Stacking/XFP module bays Redundant power supply connector Console v1.0, February 2007 Introduction