Netgear PS113 PS113 Reference Manual - Page 121
LPD Configuration and Printing, Configuring LPD on IBM AIX 4.15, Print Queue
View all Netgear PS113 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
Installation and Reference for the Model PS104/PS105/PS110/PS113 Print Server LPD Configuration and Printing LPD is a built-in printing protocol for most UNIX systems including BSD type UNIX. It is also supported in Windows NT 3.5 or later. The following sections provide information about configuring LPD on: • IBM AIX 4.15 • System V • BSD Configuring LPD on IBM AIX 4.15 Before proceeding, make sure that the print server has been assigned an IP address. To set up your AIX system for LPD printing: 1. Type the name of your print server, adding it to the /etc/hosts.lpd file. 2. Start the LPD daemon if it is not running, using the command: start src -s qdaemon 3. Start the system administration tool smith and select Print Spooling. 4. Create the required number of queues (one for each logical printer) by selecting Add a Print Queue, Remote (Printer attached to Remote Host), and then Standard Processing. Use these definitions for entering the information: • Name of queue to add Use a single-word queue name that indicates the printer attached. • Hostname for remote server Print server name as used in /etc/hosts.lpd. • Name of queue on remote server It is the logical printer number (L1 to L3 or L1 to L8) to service this queue. • Type of print spooler on remote server Use the default value. 5. Make sure the logical printers are configured in the print server. Refer to the information provided in Table 6-2 on page 6-8 for information about configuring logical printers. 6-10 UNIX Printing Using TCP/IP