Netgear WAC730 Reference Manual - Page 110
Factory Default Settings
View all Netgear WAC730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
ProSAFE Dual-Band Wireless AC Access Point WAC720 WAC730 Factory Default Settings You can use the Reset button located on the rear of the wireless access point to reset all settings to their factory defaults. This is called a hard reset. To perform a hard reset, use a sharp object to press and hold the Reset button for approximately 5 seconds (until the Test LED blinks rapidly). This returns the wireless access point to the factory configuration settings that are shown in the following table. Note: Pressing the Reset button for a shorter period of time simply causes the wireless access point to reboot. Table 3. Default configuration settings Feature Login for management and configuration LAN IPv4 management address Subnet mask for IPv4 management address LAN IPv6 management address User name (case-sensitive) for login Login password (case-sensitive) for login LAN and management features DHCPv4 client DHCPv6 client Untagged VLAN Management VLAN SNMP Syslog Spanning Tree Protocol (STP) Link Layer Discovery Protocol (LLDP) Secure Shell (SSH) Telnet Description 192.168.0.100 255.255.255.0 2001::21c:c0ff:fe69 admin password Enabled Disabled Enabled, VLAN ID 1 VLAN ID 1 Enabled Disabled Disabled Enabled Enabled Disabled Supplemental Information 110