Netgear WAC730 Reference Manual - Page 96
Apply, Enable Wireless Bridging, Wireless Point-to-Multi-Point Bridge, Enable Wireless Client
View all Netgear WAC730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
ProSAFE Dual-Band Wireless AC Access Point WAC720 WAC730 g. Specify the settings as explained in the following table: Setting Description Profile Definition Profile Name Enter a profile name that is easy to remember. The default names for the four security profiles are NETGEAR-WDS-1, NETGEAR-WDS-2, NETGEAR-WDS-3, and NETGEAR-WDS-4. Remote MAC Address Enter the MAC address of the remote wireless access point (the MAC address of AP1 or AP3 in Figure 7 on page 95). Authentication Settings Network Authentication and Data Encryption From the Network Authentication menu, select Open System, WPA-PSK, or WPA2-PSK. Your selection determines the options that the Data Encryption menu provides, and whether the WPA Passphrase (Network Key) field displays. WPA-PSK TKIP (Temporal Key Integrity Protocol) is the standard encryption method used with WPA-PSK and the only selection possible from the Data Encryption menu. In the WPA Passphrase (Network Key) field, enter a passphrase. The passphrase length needs to be between 8 and 63 characters (inclusive). WPA2-PSK AES (Advanced Encryption Standard) is the standard encryption method used with WPA2-PSK and the only selection possible from the Data Encryption menu. In the WPA Passphrase (Network Key) field, enter a passphrase. The passphrase length needs to be between 8 and 63 characters (inclusive). Note: NETGEAR recommends WPA2-PSK authentication with AES encryption if you want to use the 11n rates and speed. h. Click Apply to save your security profile settings. The Bridging page displays again. i. Repeat Step e through Step h for any other security profile that you want to edit. For example, first configure security profile NETGEAR-WDS-1 with the MAC address of AP1, and then configure security profile NETGEAR-WDS-2 with the MAC address of AP3 (see Figure 7 on page 95). 2. Activate repeater mode on the wireless access point (AP2 in Figure 7 on page 95): a. On the Bridging page, select the Enable Wireless Bridging check box. b. Select the Wireless Point-to-Multi-Point Bridge radio button. c. Clear the Enable Wireless Client Association check box to disable wireless client association (see the red circle in Figure e on page 95). Advanced Configuration 96