Netgear WNR834Bv2 WNR834Bv2 Setup Manual - Page 40
Restoring the Default User Name and Password, admin, password - region
View all Netgear WNR834Bv2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Table 1. Home Router Default Configuration Settings (continued) Feature Default Setting Time Zone Adjusted for Daylight Saving Time Firewall Disabled Inbound (communications coming in from Disabled (bars all unsolicited requests except for the Internet) traffic on port 80, the http port) Outbound (communications going out to Enabled (all) the Internet) Wireless Wireless Communication SSID Name Security Enabled NETGEAR Disabled Broadcast SSID Transmission Speed Country/Region RF Channel Operating Mode Enabled Autoa United States (North America only; otherwise varies by country and region) 6 until region selected 130 Mbps Data Rate Output Power Best Full a. Maximum Wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will vary. Network conditions and environmental factors, including volume of network traffic, building materials and construction, and network overhead lower actual data throughput rate. Restoring the Default User Name and Password You can restore the factory default configuration settings that reset the router's User Name to admin, the Password to password, and the IP address to 192.168.1.1. This procedure erases your current configuration and restores the factory defaults. To restore the factory default configuration settings: 1. Use a sharp object such as a pen or a paper clip to press and hold the default reset button, located on the rear panel of the router, for about 20 seconds (see "Back Panel" on page 3). 2. Release the reset button and wait for the router to reboot. 36 Default Configuration