Nikon 1666 Instruction Manual - Page 32

Flash Photography

Page 32 highlights

Flash Photography Flash photography is not only useful when shooting in a dark place. Even in daylight shooting, it is sometimes useful to use the flash for supplementary lighting to increase the shooting range, such as when the subject is too dark because of rear lighting or a bright background. Applicable speedlight and shooting situation Speedlight model Valid shooting modes TTL flash Non-TTL (external) auto flash Manual flash Connection method SB-80DX, SB-30, SB-28/28DX, yes SB-27, SB-26, SB-25, SB-24 SB-50DX, SB-29/29s, SB-23, SB-21B yes yes yes Cordless no yes Cordless SB-22/22S, SB-20, SB-16B, SB-15 SB-11, SB-14, SB-140 yes yes yes Cordless yes yes yes *1, *2 *1 TTL Auto Flash is possible with TTL Remote Cord SC-23. *2 When you shoot in "A" or "M" mode on the speedlight: • use the SU-2 in combination with the SC-13 to connect the SB-11 or SB-14. • use the SU-3 in combination with the SC-13 to connect the SB-140. • use the AS-15 in combination with the SC-11 or SC-15 to connect the SB-140. If the speedlight flash battery power is low or exhausted, the ready light on the speedlight flash turns on earlier than that in the viewfinder. In this case, replace the speedlight flash batteries with new ones. Ready Light flash status The ready light is built into the viewfinder and enables you to check the status of the speedlight while looking through the viewfinder. Lit: The ready light turns on when the speedlight is fully charged and ready to flash. ...The ready light does not light in Bulb mode or if the camera's battery power is fully exhausted. A 4000 2000 1000 500 Blink: After taking a picture, the ready light blinks for approx. 250 125 60 30 3 seconds as a warning if underexposure is likely with 15 8 4 2 the full-flash output of the speedlight. In this case, shoot 1 B again after checking the focus distance, aperture set- ting, range of flash shooting distance, etc. ... The ready light will also blink as a warning if the shutter speed is set between 1/500 and 1/4000 second. Select a shutter speed below 1/250 second. 32

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56

32
Flash Photography
Applicable speedlight and shooting situation
*1
TTL Auto Flash is possible with TTL Remote Cord SC-23.
*2
When you shoot in “A” or “M” mode on the speedlight:
• use the SU-2 in combination with the SC-13 to connect the SB-11 or SB-14.
• use the SU-3 in combination with the SC-13 to connect the SB-140.
• use the AS-15 in combination with the SC-11 or SC-15 to connect the SB-140.
Flash photography is not only useful when shooting in a dark place. Even in daylight
shooting, it is sometimes useful to use the flash for supplementary lighting to increase
the shooting range, such as when the subject is too dark because of rear lighting or a
bright background.
Speedlight model
Connection
method
Valid shooting modes
Manual flash
TTL flash
Non-TTL (exter-
nal) auto flash
SB-80DX, SB-30, SB-28/28DX,
SB-27, SB-26, SB-25, SB-24
SB-50DX, SB-29/29s, SB-23, SB-21B
SB-22/22
S
, SB-20, SB-16B,
SB-15
SB-11, SB-14, SB-140
yes
yes
yes
Cordless
yes
no
yes
Cordless
yes
yes
yes
Cordless
yes
yes
yes
*1, *2
If the speedlight flash battery power is low or exhausted, the ready light on the speed-
light flash turns on earlier than that in the viewfinder. In this case, replace the speed-
light flash batteries with new ones.
4000
2000
1000
500
250
125
60
30
15
8
4
2
1
B
A
Ready Light flash status
The ready light is built into the viewfinder and enables you to check the status of the
speedlight while looking through the viewfinder.
Lit:
The ready light turns on when the speedlight is fully
charged and ready to flash.
...
The ready light does not light in Bulb mode or if the camera’s
battery power is fully exhausted.
Blink:
After taking a picture, the ready light blinks for approx.
3 seconds as a warning if underexposure is likely with
the full-flash output of the speedlight. In this case, shoot
again after checking the focus distance, aperture set-
ting, range of flash shooting distance, etc.
...
The ready light will also blink as a warning if the shutter speed
is set between 1/500 and 1/4000 second. Select a shutter
speed below 1/250 second.