NordicTrack 9600 Elliptical Trainer Uk Manual - Page 8
How To Set Up The Elliptical Trainer
View all NordicTrack 9600 Elliptical Trainer manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
HOW TO SET UP THE ELLIPTICAL TRAINER HOW TO MOVE AND LEVEL THE ELLIPTICAL TRAINER Before moving the elliptical trainer, make sure that the power cord is unplugged. Note: If a CATV cable is connected to the elliptical trainer, it may be necessary to disconnect the cable if the elliptical trainer will be moved far. Due to the size and weight of the elliptical trainer, moving it requires two persons. Have two persons lift the indicated end and tip the elliptical trainer forward until it rolls on the front wheels. Carefully move the elliptical trainer to the desired location and then lower it back to the level position. CAUTION: To decrease the risk of injury, bend your legs and keep your back straight. As you raise the elliptical trainer, make sure to lift with your legs rather than your back. Do not attempt to move the elliptical trainer over uneven surfaces. If the elliptical trainer rocks slightly during use, turn the levelling feet under the front of the frame until the rocking motion is eliminated. Lift Here Wheels Levelling Feet HOW TO CONNECT THE POWER CORD If the elliptical trainer has a Basic console, it can be used with or without a power cord. To purchase a power cord, see HOW TO CONTACT CUSTOMER CARE on page 2 of this manual. If the elliptical trainer has a Workout TV console, a power cord must be used for the TV to be operated. A power cord is included with the Workout TV console. To use a power cord, first plug one end of the power cord into the jack on the front of the elliptical trainer. Plug the other end of the power cord into an appropriate outlet that is properly installed in accordance with all local codes and ordinances. Power Cord Jack HOW TO CONNECT A CATV CABLE If your elliptical trainer has a Workout TV console, a CATV cable must be connected to the elliptical trainer for cable TV stations to be viewed. Locate the cable jack on the front of the elliptical trainer. Connect the CATV cable to the cable jack. A satellite receiver, VCR, or DVD player can also be connected to the elliptical trainer. Connect a CATV cable from the coaxial output Cable Jack on your equipment (usually labelled TV OUT or RF OUT) to the cable jack. Note: Audio/video equipment without coaxial outputs (some satellite receivers and DVD players) will require an RF modulator to operate with the elliptical trainer. RF modulators and external CATV cables are not available from FreeMotion Fitness, but are available at electronics stores. See the owner's manual included with the equipment you wish to connect to see whether an RF modulator is needed. 7