NordicTrack Cxt 970 User Manual - Page 5

ASSEMBLY Assembly requires two people. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the two included allen wrenches, assembly requires a phillips screwdriver , an adjustable wrench , a rubber mallet , and pliers . As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 22. The second number refers to the quantity used in assembly. Note: Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled. M8 x 19mm M8 Split M10 Split Screw (30)-2 Washer (58)-2 Washer (22)-8 M8 Washer (33)-2 M10 Washer (63)-2 M10 Nylon Locknut (26)-4 M10 x 43mm Button Screw (65)-4 M10 x 56mm Button Screw (60)-4 M10 x 36mm Carriage Bolt (61)-2 1. Identify the Rear Stabilizer (59), which has Leveling Feet (14) threaded into it. Attach the Rear Stabilizer to 1 the Frame with the four M10 x 56mm Button Screws (60) and four M10 Split Washers (22). 60 22 60 22 1 59 2. Attach the Front Stabilizer (90) to the Frame (1) with 2 the four M10 x 43mm Button Screws (65) and four M10 Split Washers (22). Make sure that the Front Stabilizer is turned so the Wheels (45) are not 65 touching the floor. 22 45 14 65 22 1 90 5