NordicTrack E5 Si Elliptical English Manual - Page 20
Maintenance And Troubleshooting
View all NordicTrack E5 Si Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately. To clean the elliptical exerciser, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. BATTERY REPLACEMENT If the console displays become dim or if the console does not function correctly, the batteries should be replaced; most console problems are the result of low batteries. See assembly step 9 on page 9 for replacement instructions. HANDGRIP PULSE SENSOR TROUBLESHOOTING If the handgrip pulse sensor does not function properly, see step 5 on page 16. HOW TO ELIMINATE RUBBING OF THE DISCS If the Discs (12) rub against the Shields (14, 15) during use, make sure that the Center Foot (40) is installed in the Frame (1). If the Center Foot is installed, loosen the two indicated M8 x 25mm Bolt Sets (88) and the two M4 x 19mm Screws (81) in each side of the elliptical exerciser. 88 14, 15 12 1 40 81 HOW TO ADJUST THE BELT If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest setting, the belt may need to be adjusted. To adjust the belt, first see assembly steps 12 and 13 on page 11 and remove the left pedal arm and the left link arm. Then, carefully pry off the left Disc Cover (13) using a flat screwdriver. Next, remove the four screws (not shown) from the center of the left Disc (12). Gently rotate the Disc 13 12 Cover and the Disc away from the elliptical exerciser. Loosen, but do not remove, the three indicated screws (A). Insert the shaft of a 74 screwdriver B downward between the pul- 48 ley (B) and the A Idler Pulley (48). Pull the top of the screwdriver toward the front of the elliptical exerciser until the Belt (74) is tight. Then, tighten the three screws. Reattach the left disc with the four screws and then reattach the left disc cover. Next, see assembly steps 12 and 13 on page 11 and reattach the left pedal arm and the left link arm. Adjust the position of the Shields (14, 15) until the Discs (12) no longer rub against them, and then tighten the Bolt Sets (88) and the M4 x 19mm Screws (81). 20