NordicTrack E8100 Competition English Manual - Page 14

23. Tighten three Weight Storage Tubes (59) onto the Left Upright (1). 23 Tighten the remaining three Weight Storage Tubes (not shown) onto the Right Upright (2). 2 24. Set a Barbell Rest (30) onto the Left Upright (1). Set the other Barbell Rest (30) onto the Right Upright (2) at the same height. Set the Barbell Spotter (29) onto the Left Upright (1) below the Barbell Rest (30). Set the other Barbell Spotter (29) onto the Right Upright (2) at the same height. 24 30 2 29 59 1 59 59 1 30 29 25. Make sure that all parts have been properly tightened. Note: Some hardware may be left over after assembly is completed. The use of the remaining parts will be explained in ADJUSTMENT, beginning on page 15. Before using the weight bench, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAM on page 19 for proper cable routing. If there is any slack in the cables, you will need to remove it by tightening the cables. See MAINTENANCE on page 18. 14