NordicTrack E8100 Competition English Manual - Page 6

ASSEMBLY Make Assembly Easier Everything in this manual is designed to ensure that the weight bench can be assembled successfully by almost anyone. By setting aside plenty of time, assembly will go smoothly. Before beginning assembly, carefully read the following information and instructions: • Assembly requires two persons. • Because of its size, the weight bench should be assembled in the location where it will be used. Make sure that there is enough clearance to walk around the weight bench as you assemble it. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. • For help identifying small parts, use the PART IDENTIFICATION CHART on page 5. • As you assemble the weight bench, make sure all parts are oriented as shown in the drawings. • Tighten all parts as you assemble them, unless instructed to do otherwise. • Assembly requires the following tools: the included hex key(s) two adjustable wrenches one rubber mallet one standard screwdriver one Phillips screwdriver Assembly may be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches. 1. Before beginning assembly, read the important information in the box above. See the PART IDENTIFICATION CHART on page 5 for help identifying small parts. Attach the Bench Stabilizer (108) to the Bench Frame (107) with two M10 x 65mm Carriage Bolts (121) and two M10 Locknuts (65). Do not tighten the Locknuts yet. 1 107 2. Attach the Front Leg (109) to the Bench Frame (107) with two M10 x 65mm Bolts (82), two M10 Washers (66), and an M10 Locknut (65). See step 1. Tighten the M10 Locknuts (65). 2 109 66 82 65 108 121 107 65 6