NordicTrack Grt950 English Manual - Page 6
Frame Assembly
View all NordicTrack Grt950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Frame Assembly 1 1. Before beginning assembly, make sure that you understand the information on page 5. This brief introduction will save you much more time than it takes to read it. Remove the 50mm x 75mm inner cap w/ slot (A), the four M10 x 67mm carriage bolts (B), and the four M10 nylon locknuts (C) from the rear base (D). 2. Press a 50mm Square Inner Cap (25) into the indicated end of the Hack Squat Base (1). Insert four M10 x 67mm Carriage Bolts (33) up through the bottom of the Hack Squat Base (1). Slide the Hack Squat Base into the rear base (C). Note: If the Bolts fall out, stick a piece of tape over the bolt heads to hold them in. Secure the Hack Squat Base (1) to the rear base (D) with four M10 x 25mm Bolts (31). 2 1 3. Press a 75mm x 50mm Inner Cap (21) into the 3 top of the Hack Squat Upright (4). Remove the indicated two M10 x 45mm bolts (E), two M10 washers (F), and two M10 Nylon Locknuts (C) from the left upright (G). Attach the Hack Squat Upright (4) to the two M10 x 67mm Carriage Bolts (33) in the Hack Squat Base (1) with two M10 Locknuts (32). Do not tighten the Locknuts yet. Attach the Hack Squat Upright (4) to the left upright (G) with two M10 x 50mm Bolts (39) and two M10 Nylon Locknuts (C). C D A BB 31 25 D 33 33 C 21 E 39 F 4 G 32 32 33 1 6