NordicTrack R 65 Uk Manual - Page 7
Tip: Avoid pinching the Main Wire 41., Main Wire 41
View all NordicTrack R 65 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3. If there is a shipping bracket on the rear of the Frame (1), remove the screws from the shipping 3 bracket, and discard the screws and the shipping bracket. With the help of a second person, place some of the packing materials (not shown) under the rear of the Frame (1). Attach the Rear Stabilizer (3) to the Frame (1) with two M10 x 120mm Screws (44); start both 3 Screws, and then tighten them. 1 Remove the packing material from under the Frame (1). 44 4. If there is a shipping bracket on top of the Frame (1), remove the screws from the shipping bracket, and discard the screws and the shipping bracket. Have a second person hold the Upright (4) on the Frame (1). Tip: Avoid pinching the Main Wire (41). Attach the Upright (4) with four M10 x 20mm Screws (60); start all the Screws, and then tighten them. Locate the wire tie inside the Upright (4). Tie the lower end of the wire tie to the Main Wire (41). Then, pull the other end of the wire tie upward until the Main Wire is routed through the Upright. Tip: To prevent the Main Wire (41) from falling into the Upright (4), secure it to the Upright with the wire tie. 4 Wire Tie 4 Wire Tie 41 Avoid pinching the Main Wire (41) 60 1 7