NordicTrack R 65 Uk Manual - Page 8

Tip: Avoid pinching the Main Wire 41., start both Bolts, and then tighten them. Make, holes A.

Get NordicTrack R 65 PDF manuals and user guides View all NordicTrack R 65 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

5. Slide the Upright Cover (19) onto the Upright (4) and press it onto the Left and Right Shields 5 (21, 22). 19 4 21, 22 6. Attach the Accessory Tray (9) to the Upright (4) with an M6 x 50mm Screw (42). 6 42 4 9 7. Remove and discard the wire tie on the Main Wire (41). While a second person holds the Console Bracket (82) assembly near the Upright (4), route the Main Wire (41) through the notch in the Upright, through the Upright Bracket (84), and through the hole in the center of the Console Bracket. Tip: Avoid pinching the Main Wire (41). Insert the Upright Bracket (84) into the Upright (4). Attach the Upright Bracket (84) with two M8 x 50mm Bolts (49) and two M8 Locknuts (102); start both Bolts, and then tighten them. Make sure that the Locknuts are in the hexagonal holes (A). 7 82 41 84 49 4 102 A Avoid pinching the Main Wire (41) 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
8
5
19
5.
Slide the Upright Cover (19) onto the Upright
(4) and press it onto the Left and Right Shields
(21, 22).
4
21, 22
6
42
9
6.
Attach the Accessory Tray (9) to the Upright (4)
with an M6 x 50mm Screw (42).
4
7
7.
Remove and discard the wire tie on the Main
Wire (41).
While a second person holds the Console
Bracket (82) assembly near the Upright (4),
route the Main Wire (41) through the notch in the
Upright, through the Upright Bracket (84), and
through the hole in the center of the Console
Bracket.
Tip: Avoid pinching the Main Wire (41).
Insert
the Upright Bracket (84) into the Upright (4).
Attach the Upright Bracket (84) with two M8 x
50mm Bolts (49) and two M8 Locknuts (102);
start both Bolts, and then tighten them. Make
sure that the Locknuts are in the hexagonal
holes (A).
4
A
102
84
82
49
41
Avoid pinching
the Main Wire (41)