NordicTrack Vgr 940 Uk Manual - Page 7
Side a Plastic Pedal Spacer 85 and the Left Pedal Arm
View all NordicTrack Vgr 940 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
6. Align the two holes in the front of the Upright (2) with the two welded bolts on the front of the Frame (1). Next, pivot the Upright (2) about halfway to a vertical position. Refer to the inset drawing. As you raise the Upright, look into the lower end and make sure that the Harness Extension (51) and the Wire Harness (25) do not get pinched between the Upright (2) and the Frame (1). In addition, feed the slack in the Harness Extension and the Wire Harness into the Upright. Continue to raise the Upright until the four welded bolts are inserted through the bracket at the bottom of the Upright. Lift the front of the Incline Frame (5). Tighten an M10 Nylon Locknut (26) onto each welded bolt. 6 2 5 Welded Bolts 2 51 25 1 26 1 7. Identify the Left Pedal Arm (3), which has an "L" sticker on it. Next, identify the Left Pedal (41), which has the 7 letter "L" molded onto the bottom. 43 Turn over the Left Pedal Arm (3) as shown. Insert the three plastic posts on the Left Pedal (41) into the three indicated holes in the Left Pedal Arm. Make sure that 3 the Left Pedal is turned as shown. Attach the Left Pedal with three Pedal Screws (43). Welded Bolt Attach the Right Pedal (42) (not shown) to the Right Pedal Arm (4) (not shown) in the same way. 8. Apply a small amount of grease to the axle on the left Crank Arm (6). 41 8 Open Side Plastic Posts Side a Plastic Pedal Spacer (85) and the Left Pedal Arm (3) onto the axle on the left Crank Arm (6). Note: It may be helpful to use a rubber mallet to tap these parts on. Be careful not to confuse the Left Pedal Arm with the Right Pedal Arm (4) (not shown); look at the position of the round tube to identify the Left Pedal Arm. Next, tap a 3/4" Axle Cap (61) onto the axle. Attach the Right Pedal Arm (4) (not shown) in the same way. Grease 3 6 85 61 Round Tube 7