Oki B4300 Network User's Guide for OkiLAN 6020e - Page 161

Section 4 - Appendix B - Application Considerations Configuring Sun-OS v4.1.x or Ultrix v4.2 for Printing with the OkiLAN 6020e This application note describes the configuration of the printing system on the Sun-OS ver 4.1.x and Ultrix ver. 4.2 of the UNIX operating system. For clarity and brevity, the following specific names will be used to represent general devices or concepts. • lj4 - The local queue name on the Sun-OS or Ultrix system to which print jobs that are destined for a printer attached to the OkiLAN 6020e will be directed. • OKIPRINTER - The host name of the remote system which is the OkiLAN 6020e. For example, to telnet to the OkiLAN 6020e and invoke the OkiLAN 6020e Configuration utility, you would type telnet OKIPRINTER. A host name is not required for the OkiLAN 6020e, the IP Address may be used. • yourqueuename - This is the name of the queue on the OkiLAN 6020e and must end with 1, 2, 3 or 4, depending on the port selected to service the print jobs. If FF, LF or NF are the last two letters of the queue name, the job will be converted accordingly. See pages IV-15 and IV-16 for more information on remote queue names. Prerequisites Before you proceed, the following prerequisites must be met: 1. The name OKIPRINTER and the IP address assigned to the OkiLAN 6020e are in the "/etc/hosts" file on the Sun-OS or Ultrix system. 2. Make sure the LPD daemon is running on the SunOS or Ultrix system by issuing the following command at the UNIX prompt: ps aux | grep lpd TCP/IP OKI OkiLAN 6020e User's Guide IV - 79