Olympus C-50 C-50 Zoom Reference Manual (4.7 MB) - Page 19

from the slot by pulling it straight out., not forcibly eject, then remove the card

Page 19 highlights

Chapter 1 Battery/Card basics Ⅵ Loading the card Face the card the correct way and insert it into the battery/card compartment. ● Insert the card while keeping it straight. ● Inserting the card the wrong way or at an angle, could damage the contact area or cause the card to jam. ● If the card is not inserted all the way, data may not be written to the card. Ⅵ Unloading the card Push the card slowly toward the inside of the card slot with your finger until it stops. Continue to hold the card so that it does not forcibly eject, then remove the card from the slot by pulling it straight out. 4 Close the battery/card compartment cover in the direction of the arrow C, then slide it in the direction of the arrow D. C D Note ● If the battery is removed within 3 seconds after the power is turned off, the settings saved in the mode may be canceled. ● If the battery is removed from the camera for about 1 hour, some settings may return to the factory default settings even when ALL RESET is set to OFF. ● Never open the battery/card compartment cover or disconnect the optional AC adapter while the camera is in use or the camera is communicating with a computer. Doing so could destroy all data on the card. ● Destroyed data cannot be restored. ● The card may eject forcible if you take your finger off the card immediately after pushing it. 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165

18
Chapter 1
Battery/Card basics
±
Loading the card
Face the card the correct way and insert it
into the battery/card compartment.
Insert the card while keeping it straight.
Inserting the card the wrong way or at an
angle, could damage the contact area or
cause the card to jam.
If the card is not inserted all the way, data
may not be written to the card.
±
Unloading the card
Push the card slowly toward the inside of
the card slot with your finger until it stops.
Continue to hold the card so that it does
not forcibly eject, then remove the card
from the slot by pulling it straight out.
4
Close the battery/card compartment cover
in the direction of the arrow
C
, then slide it
in the direction of the arrow
D
.
If the battery is removed within 3 seconds after the power is turned off, the
settings saved in the
mode may be canceled.
If the battery is removed from the camera for about 1 hour, some settings
may return to the factory default settings even when ALL RESET is set to
OFF.
Never open the battery/card compartment cover or disconnect the optional
AC adapter while the camera is in use or the camera is communicating with
a computer.
Doing so could destr
o
y all data on the car
d.
Destroyed data cannot be restored.
The card may eject forcible if you take your finger off the card immediately
after pushing it.
Note
D
C