Olympus C-730 C-730 Ultra Zoom Reference Manual (9.3 MB) - Page 202
Troubleshooting Cont.
UPC - 050332138520
View all Olympus C-730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 202 highlights
Chapter 11 Troubleshooting (Cont.) POSSIBLE CAUSES CORRECTIVE ACTION REF. PAGE No picture is taken when the shutter button is pressed. 1 The mode dial is set to . 2 The memory gauge is full. 3 The flash has not finished charging. 4 The card access lamp blinks during recording in the mode. 5 There is a problem with the card. 6 The card is full. 7 The batteries ran out of power. 8 The monitor indications disappear, or only the battery check lights up. 9 A write-protect adhesive seal is placed on the card or there is no card in the camera (Smart Media). 1 Set the mode dial to any position except . 2 Wait until there is room in the memory gauge. 3 Remove your finger from the shutter button and wait until the orange lamp stops blinking. Take your shot again. 4 The recorded movie image data is being written to the card. You can start shooting again when the card access lamp stops blinking. 5 See the error code chart. P. 52 P. 16 P. 83 P. 75 P. 208 6 Erase unwanted pictures or insert a new card. Before erasing, download important images to a PC. 7 Replace the batteries with new ones. 8 Replace the batteries with new ones. (Do not open the battery compartment cover when the card access lamp is blinking.) 9 Insert a new card in the camera. P. 25 P. 20 P. 20 P. 25 201