Olympus PT-E06 PT-E06 Underwater Housing for the E-620 DSLR Instruction Manual - Page 13
When using the TTL cable
UPC - 050332168954
View all Olympus PT-E06 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
When using the TTL cable When connecting the optional electronic flash with the underwater TTL cable (optional: PTCB-E01), connect the hot shoe cable (optional: PHCB-01) to the camera and front cover of the Case. Connecting the underwater TTL cable 1 Turn the TTL connector cap of the Case counterclockwise and remove it. 2 Connect the underwater TTL cable (optional: PTCB-E01) to the TTL connector on the Case. Insert into the connector. Underwater TTL cable Use this mark to align the position. 3 When not using the underwater TTL cable, attach the TTL connector cap. Make sure there is no foreign matter attached to the O-rings inside the cap and on the TTL cable connector. After that, gently turn it clockwise until it stops. Turn the threaded section of the connector clockwise gently until it stops. Check O-rings Cap Connector CAUTION: If the TTL connector cap is loose, water leakage may result. How to connect the hot shoe cable 1 Turn the hot shoe cable connector cap inside the Case counter-clockwise to remove it. 2 Insert the connector of the hot shoe cable into the Case's connector and turn the connector screws all the way clockwise to connect them firmly. 3 Load the camera in the Case, and then connect the hot shoe cable to the camera. En EN 12