Olympus Stylus 770 SW Stylus 770 SW Advanced Manual (English) - Page 50
Getting to know your camera better
View all Olympus Stylus 770 SW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Getting to know your camera better Getting to know your camera better Shooting tips and information Tips before you start taking pictures The camera does not turn on even when a battery is loaded The battery is not fully charged • Charge the battery with the charger. The battery is temporarily unable to function because of the cold • Battery performance declines in low temperatures, and the charge may not be sufficient to turn on the camera. Remove the battery and warm it by putting it in your pocket for a while. No picture is taken when the shutter button is pressed The camera is in sleep mode • To save battery power, the camera automatically goes into sleep mode and the monitor turns off if there is no operation when the camera is turned on (when the lens cover is open and the monitor is on). No picture is taken even if the shutter button is fully pressed in this mode. Operate the zoom button or other buttons to restore the camera from sleep mode before taking a picture. If the camera is left for 15 minutes, it automatically turns off (the lens cover closes and the monitor turns off). Press o to turn the camera on. The mode is set to the playback mode • This mode displays the recorded picture on the monitor. Press K/h/s to select a shooting mode. The flash is charging • Wait until the # (flash charge) mark stops blinking before taking the picture. The memory gauge is full • No pictures can be taken when the memory gauge is full. Wait until there is space in the memory gauge. a Shoot Before taking any pictures (Off) b After taking one picture (Lit) Shoot c Shoot After taking several pictures (Lit) Wait d Maximum reached (All lit) The date and time have not been set The camera has been used in the same conditions from the time of purchase • No date and time have been set for the camera at the time of purchase. Set the date and time before using the camera. g "Turn the camera on" (P. 5) "X Setting the date and time" (P. 32) The battery has been pulled out of the camera • The date and time settings will be returned to the factory default settings if the camera is left without battery for approximately 1 day. Also, the date and time setting will be canceled earlier than this if the battery has been in the camera for a short period of time. Before taking important pictures, check that the date and time settings are correct. 50 EN