Onkyo HT-R340 Owner Manual - Page 34

)54@&OCPPL 1BHF  8FEOFTEBZ 'FCSVBSZ 1. Turning On STANDBY/ON STANDBY indicator STANDBY/ON A SPEAKERS B PHONES TUNING / PRESET STANDBY ENTER TONE MULTl CH + STEREO LISTENING MODE DISPLAY DIGITAL INPUT RT/PTY/TP MEMORY TUNING MODE RETURN SETUP CLEAR DVD VIDEO 1/VCR VIDEO 2 VIDEO 3 TAPE TUNER CD MASTER VOLUME RECEIVER ON/STANDBY ON/STANDBY REMOTE MODE RECEIVER DVD TAPE INPUT SELECTOR 1 2 3 C D V1 V2 V3 4 5 6 MD MULTI CH DVD 7 8 9 CDR TAPE TUNER C D +10 0 CLR HDD --/--- DIMMER SLEEP CH DISC ALBUM VOL Turning On the AV Receiver 1 AV receiver STANDBY/ON Remote controller RECEIVER or Press the [STANDBY/ON] button. Alternatively, press the remote controller's [RECEIVER] button followed by the [ON/STANDBY] button. The AV receiver comes on, the display lights up, and the STANDBY indicator goes off. ON/STANDBY To turn the AV receiver off, press the [STANDBY/ON] button, or the remote controller's [ON/STANDBY] button. The AV receiver will enter Standby mode. To prevent any loud surprises the next time you turn on the AV receiver, always turn down the volume before turning it off. Smooth Operation in a Few Easy Steps To ensure smooth operation, here's a few easy steps to help you configure the AV receiver before you use it for the very first time. These settings only need to be made once. ■ Have you connected a component to a digital audio input? If you have, see "Assigning Digital Inputs to Input Sources" on page 35. COAXIAL OPTICAL ■ Have you connected an Onkyo MD recorder, CD recorder, OUT IN or next generation HDD-compatible component? If you have, see "Changing the Input Display" on page 35. TAPE CD recorder, MD recorder Testing the speakers To test that all of the speakers are working properly, press the remote controller's [TEST TONE] button. The test tone will be output by each speaker in turn and the name of each speaker will appear on the display. To turn off the test tone, press the [TEST TONE] button again. • If the test tone is not produced by a speaker, or it's produced by a speaker other than that shown on the display, you may have wired the speakers incorrectly and you should check your connections (see page 20). • If the test tone is not produced by a speaker and its name does not appear on the display, you may have set the speaker settings incorrectly (see page 52). 34