Onkyo HT-R530 Owner Manual - Page 39

)54@&OCPPL 1BHF  .POEBZ 'FCSVBSZ 1. Common Functions-Continued Using the Sleep Timer With the sleep timer, you can set the AV receiver so that it automatically turns off after a set period. Press the remote controller's [SLEEP] button repeatedly to select the required sleep time. You can set the sleep time from 90 to 10 minutes in 10 minute steps. The SLEEP indicator appears on the display when the sleep timer has been set, as shown. The specified sleep time appears on the display for about five seconds, then the previous display reappears. SLEEP indicator Adjusting Speaker Levels You can adjust the level of each speaker in speaker set A while listening to an input source. These temporary adjustments are cancelled when the AV receiver is set to Standby. 1 Use the remote controller's [CH SEL] button to select each speaker, and use the [LEVEL-] and [LEVEL+] buttons to adjust the volume. You can adjust the volume of each speaker from -12 dB to +12 dB (-15 dB to +12 dB for the subwoofer). To cancel the sleep timer, press the [SLEEP] button repeatedly until the SLEEP indicator disappears. To check the remaining sleep time, press the [SLEEP] button. Note that if you press the [SLEEP] button while the sleep time is being displayed, you'll shorten the sleep time by 10 minutes. Using Headphones You can connect a pair of stereo headphones (1/4-inch phone plug) to the AV receiver's PHONES jack for private listening, as shown. STANDBY/ON A SPEAKERS B PHONES PURE AUDIO Notes: • You cannot use this function while the AV receiver is muted. • Speakers that are set to No or None in the Speaker Configuration cannot be adjusted. ■ Speaker Set B While speaker set B is on, you can also adjust the levels of the left and right speakers in speaker set B, from -12 dB to +12 dB. • These settings are stored when the AV receiver is set to Standby. • While speaker set B is on, you cannot adjust the levels of speaker set A's surround back speakers. ■ Headphones While a pair of headphones is connected, you can adjust the volume of the left and right channels individually, from -12 dB to +12 dB each. Notes: • Always turn down the volume before connecting your headphones. • Speaker sets A and B are turned off while the headphones plug is inserted in the PHONES jack. • When you connect a pair of headphones, the listening mode is set to Stereo, unless it's already set to Pure Audio, Mono, Stereo, or Direct. • When the multichannel DVD input is selected, only the front left and front right channels can be heard in the headphones. • These settings are stored when the AV receiver is set to Standby. ■ Multichannel DVD Input While the multichannel DVD input is selected, you can adjust the level of each 5.1 channel input individually, from -12 dB to +12 dB. (-30 to +12 dB for the subwoofer.) • These settings are stored when the AV receiver is set to Standby. • Individual speaker levels can also be adjusted in "3. MultiLevel Setup" (see page 47). 39