Onkyo HT-S9800THX Basic/Advanced Manual - English - Page 41

>>Specifications >>Advanced Setup >>Listening Modes >>Network Functions >>Basic Manual Troubleshooting | Supplementary Information, etc. ˙ 2� Dolby Setting Item Loudness Management ˙ 3� DTS Setting Item DTS Auto Surround Default Value On Setting Details When playing Dolby TrueHD, enable the dialog normalization function which keeps the volume of dialog at a certain level. Note that when this setting is Off, the Late Night function that allows you to enjoy surround at low volumes is fixed to off when playing Dolby Digital Plus/Dolby TrueHD. "On": When this function is to be used "Off": When this function is not to be used Default Value On Setting Details When inputting DTS signals that include extended channel information, the optimum listening mode is automatically selected according to the extended information contained in the input signal and the speaker configuration of this unit when playing in the straight decoding listening mode. "On": Use this function "Off": Audio is played using the same amount of channels in the input signal according to the speaker configuration of this unit. • The ES Matrix and ES Discrete listening modes cannot be selected if this function is set to "Off". ˙ 5� Volume Setting Item Volume Display Default Value Absolute Mute Level ʵ㱣dB Maximum Volume Off Power On Volume Last Headphone Level 0 dB Setting Details Switch the volume display between the absolute value and relative value. The absolute value 82 is equivalent to the relative value 0dB. "Absolute": Absolute value such as "1" and "99" "Relative": Relative value such as "-81dB" and "+18dB" • If the absolute value is set to 82, "82Ref" will appear on the display. Set the volume lowered from the listening volume when muting is on. Select a value from "ʵ㱣dB", "ʵ40dB", and "ʵ20dB". Set the maximum value to avoid too high volume. Select a value from "Off", "50" to "99". (When "Volume Display" is set to "Absolute") Set the volume level of when the power is turned on. Select a value from "Last" (Volume level before entering standby mode), "Min", "1" to "99" and "Max". (When "Volume Display" is set to "Absolute") • You cannot set a higher value than that of "Maximum Volume". Adjust the output level of the headphones. Select a value between "ʵ12 dB" and "ʴ12 dB". ˙ 4� LFE Level Set the low-frequency effect (LFE) level for Dolby Digital series, DTS series, Multichannel PCM, and DSD signals. Setting Item LFE Level 16 Default Value 0dB Setting Details Select the low-frequency effect (LFE) level of each type of signal from "0dB" to "ʵ㱣dB". If the lowfrequency effect sound is too strong, select "ʵ20dB" or "ʵ㱣dB".