Onkyo HT-S9800THX Basic/Advanced Manual - English - Page 49
. When 3. Audio Adjust - Volume - Volume, When playing using AirPlay or Spotify Connect
View all Onkyo HT-S9800THX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
>>Specifications >>Advanced Setup >>Listening Modes >>Network Functions >>Basic Manual Troubleshooting | Supplementary Information, etc. 6� Multi Zone Make settings related to Multi-zone Connection, such as the volume for the separate room. ˙ 1� Zone 2 Setting Item Default Value Maximum Volume Off Power On Volume Last Setting Details Set the maximum value for Zone 2 to avoid too high volume. Select a value from "Off", "50" to "99". (When "3. Audio Adjust" - "Volume" - "Volume Display" is set to "Absolute") Set the Zone 2 volume level of when this unit is turned on. Select a value from "Last" (Volume level when the unit was turned off), "Min", "1" to "99" and "Max". (When "3. Audio Adjust" - "Volume" "Volume Display" is set to "Absolute") • You cannot set a higher value than that of "Maximum Volume". 7� Miscellaneous Change the frequency step for the tuner, update the firmware, and perform Initial Setup, etc. ˙ 1� Tuner Setting Item AM / FM Frequency Step (North American models) AM Frequency Step (European models) Default Value Setting Details 10 kHz / 0.2 MHz Select a frequency step depending on your area of residence. Select "10 kHz/0.2 MHz" or "9 kHz/0.05 MHz". • When this setting is changed, all radio presets are deleted. 9 kHz Select a frequency step depending on your area of residence. Select "10 kHz" or "9 kHz". • When this setting is changed, all radio presets are deleted. ˙ 2� Remote Play Zone Setting Item Remote Play Zone Default Value Auto Setting Details When playing using AirPlay or Spotify Connect, or when using the Music Server feature to play remotely from your PC, you can set whether to play in the main room (where this unit is) or in a separate room (ZONE 2). "Auto": When the main room input selector is NET, music is played in the main room. When the separate room input selector is NET and the main room is other than NET, then the music is played in the separate room. "Main", "Zone2": Select when limiting the play zone to a particular room. For example, when playing only in the separate room, select "Zone 2". • This feature may not work if something is already being played with the same network feature. 24 ˙ 2� Remote ID Setting Item Remote ID Default Value 1 Setting Details Select an ID for the unit's remote controller from "1", "2", and "3" to prevent interference between the unit and other ONKYO components that are installed in the same room. After changing the ID on the main unit, change the ID on the remote controller accordingly with the following procedure. While holding down MODE, press the following buttons for about 3 seconds. • To change the remote controller ID to "1": (The remote indicator flashes once.) • To change the remote controller ID to "2": (The remote indicator flashes twice.) • To change the remote controller ID to "3": (The remote indicator flashes three times.)