Onkyo TX-NR515 Owner Manual - Page 35

1 Turn on the AV receiver and the connected TV. On the TV, select the input to which the AV receiver is connected. 2 Set the speaker setup microphone at the Main Listening Position B, and connect it to the SETUP MIC jack. SETUP MIC jack Speaker setup microphone The speaker setting menu appears. Note • The on-screen menus appear only on a TV that is connected to the HDMI OUT MAIN. If your TV is connected to other video outputs, use the AV receiver's display when changing settings. 3 When you've finished making the settings, press ENTER. 2EQ: Auto Setup Speakers Type (Front) Powered Zone 2 Surround Back/Front High AUDYSSEY Normal No Surround Back Perform the "Speaker Setup" according to your speaker configuration: - Speakers Type (Front) (➔ page 52) - Powered Zone 2 (➔ page 52) - Surround Back/Front High (➔ page 52) 4 Use R/X to select "Audyssey Quick Start" or "Audyssey 2EQ Full Calibration". 5 Press ENTER. Audyssey 2EQ® Room Correction and Speaker Setup starts. Test tones are played through each speaker as Audyssey 2EQ Room Correction and Speaker Setup runs. This process takes a few minutes. Please refrain from talking during measurements and do not stand between speakers and the microphone. Do not disconnect the speaker setup microphone during Audyssey 2EQ Room Correction and Speaker Setup, unless you want to cancel the setup. If you select "Audyssey Quick Start", you will go to step 8. 6 Place the speaker setup microphone at the next position, and then press ENTER. Audyssey 2EQ performs more measurements. This takes a few minutes. 7 When prompted, repeat step 6. 8 Use R/X to select an option, and then press ENTER. 2EQ: Auto Setup Subwoofer Front Center Surround Front High Surround Back Surround Back Ch -- Review Speaker Configuration -- Yes 100Hz 40Hz 100Hz None 120Hz 2ch AUDYSSEY Save Cancel The options are: ` Save: Save the calculated settings and exit Audyssey 2EQ Room Correction and Speaker Setup. ` Cancel: Cancel Audyssey 2EQ Room Correction and Speaker Setup. Turning On & Basic Operations Tip • You can view the calculated settings for the speaker configuration, speaker distances, and speaker levels by using F/S. 9 Use R/X to select a target, and use F/S to change the setting. After the results of Audyssey 2EQ have been saved, the menu will display the "Audyssey" (➔ page 55), "Dynamic EQ" (➔ page 56), "Dynamic Volume" (➔ page 56) settings. Note • When "Audyssey Quick Start" has been used for measurement, "Audyssey" cannot be selected. • These settings are applied to all input selectors. 10 Press ENTER. 11 Disconnect the speaker setup microphone. Note • You can cancel Audyssey 2EQ Room Correction and Speaker Setup at any point in this procedure simply by disconnecting the setup microphone. • Do not connect or disconnect any speakers during Audyssey 2EQ Room Correction and Speaker Setup. • If the AV receiver is muted, it will be unmuted automatically when Audyssey 2EQ Room Correction and Speaker Setup starts. • Changes to the room after Audyssey 2EQ Room Correction and Speaker Setup requires you run Audyssey 2EQ Room Correction and Speaker Setup again, as room EQ characteristics may have changed. En-35