Optoma ZU500T-W ZH500T User Manual - Page 18

Powering the Projector On/Off

Get Optoma ZU500T-W PDF manuals and user guides View all Optoma ZU500T-W manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

SETUP AND INSTALLATION Powering the Projector On/Off Powering On the Projector 1. Securely connect the power cord and signal cable. When connected, the POWER/STANDBY LED will turn Red. 2. Turn on the lamp by pressing the " " button either on the projector or on the remote. At this moment, the POWER/ STANDBY LED will now turn Blue. ① The startup screen will display in approximately 6 sec- onds. 3. Turn on and connect the source that you want to display on the screen (computer, notebook, video player, etc). The projector will detect the source automatically. `` If you connect multiple sources at the same time, press the "INPUT" button on the control panel to switch between inputs. Note: W hen the power mode is in standby mode (power consumption < 0.5W), the VGA output/Wire remote/LAN will be deactivated when the projector is in standby. Audio out loop-through is always active in standby mode. HDBaseT control is always deactivated in standby mode. 1 POWER/STANDBY Note: Turn on the projector first and then select the signal sources. 18 English

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
18 English
SETUP AND INSTALLATION
Powering the Projector On/Off
Powering On the Projector
1. Securely connect the power cord and signal cable. When connected, the POWER/STANDBY LED will turn Red.
2. Turn on the lamp by pressing the
“
” button either on the projector or on the remote. At this moment, the
POWER/ STANDBY LED will now turn Blue
.
①
The startup screen will display in approximately 6 sec- onds.
3. Turn on and connect the source that you want to display on the screen (computer, notebook, video player, etc).
The projector will detect the source automatically.
If you connect multiple sources at the same time, press the “INPUT” button on the control panel to switch
`
between inputs.
Note:
When the power mode is in standby mode (power consumption < 0.5W), the VGA output/Wire remote/LAN
will be deactivated when the projector is in standby. Audio out loop-through is always active in standby mode.
HDBaseT control is always deactivated in standby mode.
Note:
Turn on the projector first and then select the signal sources.
POWER/STANDBY
1