Optoma ZU500T-W ZH500T User Manual - Page 37

USER CONTROLS Options Logo Use this function to set the desired startup screen. If changes are made they will take effect the next time the projector is powered on. •• Default: The default startup screen. •• User: Use stored picture from "Logo Capture" function. Logo Capture Press ► button to capture an image of the picture currently displayed on screen. Note: "Logo Capture" is not available when 3D is enabled. Before active this function, it is recommended that "Aspect Ratio" is set to the "Auto". Auto Source •• On: The projector will search for other signals if the current input signal is lost. •• Off: The projector will only search current input connection. Input Press ► button to enable/disable input sources. The projector will not search for inputs that are not selected. Auto Power Off (Min) Sets the countdown timer interval. The countdown timer will start, when there is no signal being sent to the projector. The projector will automatically power off when the countdown has finished (in minutes). Sleep Timer Sets the countdown timer. The countdown timer will start, with or without a signal being sent to the projector. The projector will automatically power off when the countdown has finished (in minutes). SSI Settings •• SSI Hours Used (Normal) Display the projection time of normal mode. •• SSI Hours Used (ECO) Display the projection time of ECO mode. •• SSI Power Mode Normal: Normal mode. ECO: Use this function to dim the projector SSI which will lower power consumption and extend the SSI life. High Altitude •• On: The built-in fans run at high speed. Select this option when using the projector at altitudes above 2500 feet/762 meters or higher. •• Off: The built-in fans automatically run at a variable speed according to the internal temperature. English 37