Optoma ZU500T-W ZH500T User Manual - Page 35

Settings

Get Optoma ZU500T-W PDF manuals and user guides View all Optoma ZU500T-W manuals
Add to My Manuals
Save this manual to your list of manuals

Page 35 highlights

USER CONTROLS Settings Language Choose the multilingual OSD menu. Press the ◄ or ► button into the sub menu and then use the ▲ or ▼ button to select your preferred language. Press ► on the remote control to finalize the selection. Menu Location Choose the menu location on the display screen. VGA Output (Standby) Choose "On" to enable VGA OUT connection. LAN (Standby) Choose "On" to enable LAN connection. Choose "Off" to disable LAN connection. Test Pattern Display a test pattern. Direct Power On Choose "On" to activate Direct Power mode. The projector will automatically power on when AC power is supplied, without pressing the key on the projector control panel or on the remote control. Signal Power On If Signal Power On is set to ON the projector will wake up automatically from standby mode if the input source is changed from inactive to active. Reset Choose "Yes" to return the parameters on all menus to the factory default settings. English 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
English 35
USER CONTROLS
Settings
Language
Choose the multilingual OSD menu. Press the ◄ or ► button into the sub menu and then use the ▲ or ▼ button to
select your preferred language. Press ► on the remote control to finalize the selection.
Menu Location
Choose the menu location on the display screen.
VGA Output (Standby)
Choose “On” to enable VGA OUT connection.
LAN (Standby)
Choose “On” to enable LAN connection. Choose “Off” to disable LAN connection.
Test Pattern
Display a test pattern.
Direct Power On
Choose “On” to activate Direct Power mode. The projector will automatically power on when AC power is supplied,
without pressing the
key on the projector control panel or on the remote control.
Signal Power On
If Signal Power On is set to ON the projector will wake up automatically from standby mode if the input source is
changed from inactive to active.
Reset
Choose “Yes” to return the parameters on all menus to the factory default settings.