Panasonic 26PSU1U6 Tech Data - Service Manual - Page 117
Wiring System Diagram for Group Control, Group control using 2 signal receiving units
View all Panasonic 26PSU1U6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
7-17. Wiring System Diagram for Group Control This diagram shows when several units (maximum of 8) are controlled by a signal receiving unit (main unit). In this case, a signal receiving unit can be connected at any indoor unit. 1. Specifications Wiring procedure Wire according to the diagram at left: Address setting is executed automatically when the outdoor unit is turned on. Each successive unit will respond at one-second intervals following the order of the group address when the remote controller is operated. Group control using 2 signal receiving units It does not matter which of the 2 signal receiving units you set as the main controller. When using multiple signal receiving units (up to 2 1 Remote Controller can be used), one is the main signal receiving unit and the other is the sub-signal receiving unit. (main) (sub) 12 Connection wiring for group control 12 To set up a sub-signal receiving unit, change its remote control address connector (RCU. ADR) located on its PCB from main to sub position Wire joint (main: when shipped from factory). 12 12 12 12 Indoor unit No. 1 U1 U2 Indoor unit No. 2 U1 U2 Indoor unit No. 3 U1 U2 Indoor unit No. 8 U1 U2 U1 U2 U1 U2 U1 U2 Outdoor unit Outdoor unit Outdoor unit U1 U2 Outdoor unit : Ground (earth) 1-111