Panasonic DMC FS7G Digital Still Camera - Page 95
Motion Recording Was Cancelled Due To The Limitation Of The, Writing Speed Of The Card]
UPC - 037988988693
View all Panasonic DMC FS7G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Others [MEMORY CARD ERROR FORMAT THIS CARD?] • This card has a format which is not recognized by the camera. > Format the card again with the camera after saving necessary data on a PC etc. (P25) [PLEASE TURN CAMERA OFF AND THEN ON AGAIN]/[SYSTEM ERROR] • This message appears when the camera is not operating properly. > Turn the camera off and on. If the message persists, contact the dealer or your nearest Service Center. [MEMORY CARD PARAMETER ERROR] > Use a card compatible with this unit. (P17) • You can only use an SDHC Memory Card if using cards with 4 GB or more capacity. [MEMORY CARD ERROR PLEASE CHECK THE CARD] • An error has occurred accessing the card. > Insert the card again. > Insert a different card. [READ ERROR/WRITE ERROR PLEASE CHECK THE CARD] • It has failed to read or write data. > Remove the card after turning the power [OFF]. Insert the card again, turn the power on, and try to read or write the data again. • The card may be broken. > Insert a different card. [MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE WRITING SPEED OF THE CARD] • When you set the recording quality to [ ] or [ ], we recommend using a high-speed card with "10MB/s" or greater displayed on the package. • In the event that it stops even after using a "10MB/s" card or higher, the data writing speed has deteriorated so it is recommended to make a backup and then format (P25). • Depending on the type of SD Memory Card or SDHC Memory Card, motion picture recording may stop in the middle. [A FOLDER CANNOT BE CREATED] • A folder cannot be created because there are no remaining folder numbers that can be used. (P83) > Format the card after saving necessary data on a PC etc. (P25) If you execute [NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100. (P24) [PICTURE IS DISPLAYED FOR 4:3 TV]/[PICTURE IS DISPLAYED FOR 16:9 TV] • The AV cable (P88) is connected to the camera. > Press [MENU/SET] if you want to delete this message at once. > Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect. (P25) • This message also appears when the USB connection cable is connected to the camera only. In this case, connect the other end of the USB connection cable to a PC or a printer. (P81, 84) [PRINTER BUSY]/[PLEASE CHECK THE PRINTER] • The printer cannot print. > Check the printer. VQT2C70 95