Panasonic EW3152W Instruction Manual - Page 19
Storing, completed., press
View all Panasonic EW3152W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
STORING MEASUREMENT VALUES This product can separately store 90 measurements each for two persons. After measurement, the (D (D will light. SY& Press the M/R MIIHg (memory/recall) button DIA. mmHg ao with the number corresponding to 7unlian the person for which measurements should be stored. SY& DIA. Writ C ▪ M/R (=> 10 20 se°4 /R ) C 10 Pulse Mire Number of stored ) data 20 2 Example: Person A: Press 0 Person B: Press (D Storing is completed. • Up to 90 measurement values can be stored. When the memory is full and additional values are stored, the oldest value in memory will be deleted and the new value will be stored. • If measurements could not be taken properly (the E mark is shown instead of the blood pressure value), measurement values cannot be stored. * However, if the E mark is displayed for only the pulse value, data can be stored. To erase all measured values stored in memory: 1. Recall the measurement value for the person whose data you want to delete by pressing that person's M/R (memory/recall) button. 2. Press the same M/R (memory/recall) button again, and hold it pressed until the measurement values disappear (approximately 3 seconds or more). * It is not possible to erase single measurement values. On/Off Stet To switch off the blood pressure monitor, press the On/Off Start button. • If you forget to switch it off, the blood pressure monitor will switch off automatically after approximately 5 minutes. 19