Panasonic KX-TG2248S 2.4 Ghz Digital Cdl - Page 20

Preparing the Answering System Pre-recorded greeting If you do not record a greeting (p. 19), one of two greetings will be played when a call is received, depending on the caller's recording time (see below). To check the pre-recorded greeting, press [GREETING CHECK]. • A pre-recorded greeting will be played as follows: s When the recording time is set to "1 minute", "2 minutes" or "3 minutes": "Hello, we are not available now. Please leave your name and phone number after the beep. We will return your call." • If recording time runs out, the unit will automatically switch to the "Greeting only" mode (see below), and no new messages will be recorded. s When the recording time is set to "Greeting only": "Hello, we are not available now. Please call again. Thank you for your call." Flash Memory Message Backup (Message storage) Messages stored in memory will not be affected by power failures. All messages are saved until you erase them. Caller's Recording Time Handset You can select "1 minute", "2 minutes", "3 minutes" or "Greeting only" for the caller's recording time. The factory preset is "3 minutes". 1 Press [MENU]. > Initial setting 2 Scroll to "Initial setting" by pressing [ ] or [ ], then press Select. Exit Select > >>>> > >>>> > Set answering 3 Scroll to "Set answering" by pressing [ ] or [ ], then press Select. Back Select > Recording time 4 Scroll to "Recording time" by pressing [ ] or [ ], then press Select. Back Select > > 5 Select the recording time by pressing [ ] or [ ]. • You can also select the recording time by pressing dialing buttons [1], [2], [3] or [0] (Greeting only). 6 Press Save, then press [OFF]. > Recording time :3min Back Save • When "Greeting only" is selected, the unit will answer calls by playing the greeting message, then hang up. The unit will not record any incoming messages. • If you change the recording time to "Greeting only" when there are no new messages stored in the Answering System, the number of messages will disappear from the base unit display. 20