Panasonic KX-TG2248S 2.4 Ghz Digital Cdl - Page 52

Troubleshooting Problem The handset display exits the Caller List or phone book. You cannot page the handset or base unit. You cannot have a conversation using the headset. Cause & Remedy • Do not pause for over 60 seconds while searching. • The handset is too far from the base unit. • The handset user is making an outside call, viewing the Caller List/phone book or listening to messages. Wait until the IN USE/CHARGE indicator light goes out. • The handset or base unit is in use. Try again later. • Make sure the optional headset is connected properly (p. 49). • If "SP-phone" is displayed on the handset, press [ ] to switch to the headset. Answering System Problem The Answering System is on, but incoming messages are not recorded. You cannot listen to recorded messages. " FULL " is displayed and the ANSWER ON indicator flashes rapidly. No new messages are recorded. You cannot operate the Answering System with the base unit. You cannot operate the Answering System from a touch tone phone. Cause & Remedy • The recording time is set to "Greeting only". Select "1 minute", "2 minutes" or "3 minutes" (p. 20). • Memory is full. Erase unnecessary messages (p. 43). • Make sure the unit is not being used. • Memory is full. Erase unnecessary messages (p. 43). • The handset user is operating the Answering System, or is on the phone. Wait until the IN USE/CHARGE indicator light goes out. • Make sure you enter the correct remote code (p. 45). • The Answering System may not respond if the tones are too short to activate the unit. Press each button firmly. • The Answering System is off. Turn it on (p. 47). 52