Panasonic MCV3110 MCV3110 User Guide - Page 30

Removing And Installing Lower Plate

Page 30 highlights

WARNING Electrical Shock or Personal Injury Hazard Disconnect the electrical supply before servicing or cleaning the unit. Failure to do so could result in electrical shock or personal injury from cleaner suddenly starting. Two Latches Deux taquets Dos pestillos Removing and Installing Lower Plate ➢ Always place paper under nozzle whenever lower plate is removed to protect floor. ➢ Place handle in upright position and turn vacuum over to expose lower plate. Locking Tabs Loquets de sûreté Lengüetas de cierre ➢ Release lower plate by pressing two (2) latches and two (2) locking tabs inward as shown. ➢ Remove lower plate and remove any residue that may exist in belt area. Lower Plate Plaque inférieure Base inferior ➢ Reinstall lower plate by hooking front end of lower plate into slots on front of nozzle housing. ➢ Make sure all wires are routed properly and not pinched. ➢ Press lower plate until locking tabs snap into place then push two (2) latches outward. - 30 -

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48

- 30 -
WARNING
Electrical Shock or Personal Injury Hazard
Disconnect the electrical supply before servicing or cleaning the unit.
Failure to do so could result in electrical shock or personal injury from
cleaner suddenly starting.
Removing and Installing Lower Plate
Always place paper under nozzle
whenever lower plate is removed to
protect floor.
Place handle in upright position and turn
vacuum over to expose lower plate.
Release lower plate by pressing two (2)
latches and two (2) locking tabs inward
as shown.
Remove lower plate and remove any
residue that may exist in belt area.
Reinstall lower plate by hooking front
end of lower plate into slots on front of
nozzle housing.
Make sure all wires are routed properly
and not pinched.
Press lower plate until locking tabs snap
into place then push two (2) latches
outward.
Locking Tabs
Loquets de
s
û
ret
é
Leng
ü
etas
de cierre
Lower Plate
Plaque inf
é
rieure
Base inferior
Two Latches
Deux taquets
Dos pestillos