Panasonic MCV3110 MCV3110 User Guide - Page 40

Before Requesting Service, Possible Solution

Get Panasonic MCV3110 - COMMERCIAL VACUUM PDF manuals and user guides View all Panasonic MCV3110 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

BEFORE REQUESTING SERVICE WARNING Electric Shock or Personal Injury Hazard. Disconnect the electrical supply before servicing or cleaning the unit. Failure to do so could result in electric shock or personal injury from cleaner suddenly starting. Review this chart to find do-it-yourself solutions for minor performance problems. Any service needed, other than those described in these Operating Instructions, should be performed by an authorized service representative. PROBLEM Cleaner will not run. POSSIBLE CAUSE 1. Unplugged at wall outlet. 2. ON-OFF switch not turned on. 3. Tripped circuit breaker/blown fuse at household service panel. POSSIBLE SOLUTION 1. Plug in firmly. Push ON-OFF switch to ON. 2. Push ON-OFF switch to ON. 3. Reset circuit breaker or replace fuse. Poor job of dirt pickup. 1. Full or clogged dust bag. 2. Broken belt. 3. Carpet height selector incorrect. 4. Clogged hose or nozzle. 5. Hose not inserted fully. 6. Worn agitiator. 7. Hole in hose. 8. Dust cover improperly installed. 9. Belt not installed on motor shaft. 1. Change bag. 2. Replace belt. 3. Set in the correct position. 4. Clean hose or nozzle area. 5. Insert hose. 6. Replace agitator. 7. Replace hose. 8. Properly install dust cover. 9. Install belt on motor shaft. Dust escapes the paper bag. 1. Bag improperly installed. 2. Bag torn. 1. Properly install bag. 2. Replace bag. Cleaner picks up moveable rugs or pushes too hard. 1. Wrong pile height setting. 1. Adjust setting. - 40 -

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
- 40 -
BEFORE REQUESTING SERVICE
WARNING
Electric Shock or Personal Injury Hazard.
Disconnect the electrical supply before servicing or cleaning the unit. Failure to do
so could result in electric shock or personal injury from cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance problems.
Any service needed, other than those described in these Operating Instructions,
should be performed by an authorized service
representative.
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
Cleaner will
1.
Unplugged at wall outlet.
1.
Plug in firmly.
Push ON-OFF
not run.
switch to ON.
2.
ON-OFF switch not turned on.
2.
Push ON-OFF switch to ON.
3.
Tripped circuit breaker/blown
3.
Reset circuit breaker or replace
fuse at household service panel.
fuse.
Poor job of dirt
1.
Full or clogged dust bag.
1.
Change bag.
pickup.
2.
Broken belt.
2.
Replace belt.
3.
Carpet height selector incorrect.
3.
Set in the correct position.
4.
Clogged hose or nozzle.
4.
Clean hose or nozzle area.
5.
Hose not inserted fully.
5.
Insert hose.
6.
Worn agitiator.
6.
Replace agitator.
7.
Hole in hose.
7.
Replace hose.
8.
Dust cover improperly installed.
8.
Properly install dust cover.
9.
Belt not installed on motor shaft.
9.
Install belt on motor shaft.
Dust escapes
1.
Bag improperly installed.
1.
Properly install bag.
the paper bag.
2.
Bag torn.
2.
Replace bag.
Cleaner picks up
1.
Wrong pile height setting.
1.
Adjust setting.
moveable rugs
or pushes too
hard.