Panasonic PT-FW300U Lcd Projector - Page 11
Read this first, Minimum required setting screen
UPC - 791871111826
View all Panasonic PT-FW300U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Preparation Read this first Minimum required setting screen When you start the projection for the first time, the minimum required setting screen for projection will be displayed. J INITIAL SETTING 1. Select the required language setting by pressing I H, then press the ENTER button. INITIAL SETTING ENGLISH INSTALLATION Select the required installation method. FRONT/DESK FRONT/CEILING REAR/DESK REAR/CEILING Setting on a desk/floor and projecting from front Mounting on the ceiling and projecting from front Setting on a desk/floor and projecting from rear Mounting on the ceiling and projecting from rear PLEASE SELECT LANGUAGE SELECT ENTER 2. Select the minimum required settings to start the projection. Press the RETURN button to return to the language setting menu. Press F G to move through the menu items. Press I H to select the required setting. Press the ENTER button to complete the setting and start the projection. INITIAL SETTING INSTALLATION SCREEN FORMAT SCREEN POSITION FRONT/DESK 16:10 CENTER HIGH ALTITUDE MODE OFF SWITCH TO HIGH ALTITUDE MODE "ON" IF OVER 1400m(4593Ft). RETURN SELECT ENTER SCREEN FORMAT Select the required screen format by pressing I H. 16:10 When project on a 16:10 or 4:3 screen. 16:9 When project on a 16:9 screen. SCREEN POSITION When SCREEN FORMAT menu is set to 16:9, you can select the menu display position by pressing I H. LOW Displays the menu in the lower part of the screen. CENTER Displays the menu in the middle of the screen. HIGH Displays the menu in the upper part of the screen. HIGH ALTITUDE MODE If you use the projector at high elevation, the HIGH ALTITUDE MODE setting need to be ON to set the fan speed high. OFF The fan speed is low. ON The fan speed is high. NOTE: • At 1 400 - 2700 m (4 593 - 8 858 ft) above sea level, the setting must be ON. • The loudness of fan noise depends on the HIGH ALTITUDE MODE setting. NOTE: Once you finish the minimum requirement setting, it will not be displayed again unless the projector is initialized. See "INITIALIZE ALL" on page 43. You can change the each setting from the main menu. See "Menu Navigation" on page 30. ENGLISH - 11